hope4ia Posted November 24, 2016 Share Posted November 24, 2016 We have 9 units, but only unit 1 is being detected. Do you need to plug them in, in order? Or is there just a communication issue from the first box where the computer is plugged into to all the others? Thanks Link to comment Share on other sites More sharing options...
k6ccc Posted November 24, 2016 Share Posted November 24, 2016 They can be in any order. Check for a cable problem. Link to comment Share on other sites More sharing options...
James Hill Posted November 25, 2016 Share Posted November 25, 2016 I found that if one of my units do not have power then it doesn't get detected. Hope this helps. Link to comment Share on other sites More sharing options...
toddm1919 Posted November 25, 2016 Share Posted November 25, 2016 Are you using the hardware utility? If so, make sure you max unit number is set to at least nine. Link to comment Share on other sites More sharing options...
Jim Hans Posted November 25, 2016 Share Posted November 25, 2016 Silly question .... in the hardware utility you did change each unit ID to be from 1 to 9 didn't you? Hook up your first unit...HU find it? Add another, refresh the HU, it should have found both. If so add the third. Keep doing this until you find the first unit that isn't found, replaced that cat five cable. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now