Jump to content
Light-O-Rama Forums

Pixcon16 connection


jeffgilchrist

Recommended Posts

I recently purchased the Pixcon16 to run some arches and trees using smart pixels.  I have followed the instructions in the manual and read some on this board but still cannot get my laptop to recognize the pixcon16.  I get a solid green light and blinking red.  Running windows 10 with version 4.2.12 of the LOR software.  Things I have tried:

turning off my wireless

running in DHCP

Running static using the default IP

running the diagnostic tool that pops up in the configuration program

using a validated cat5 cable

At this point I am frustrated and asking for help, I'm sure it is something easy but it alludes me right now.

 

Thanks,

Jeff

Link to comment
Share on other sites

I think I may have figured it out, I have my laptops network adapter set to the exact same static IP address as my pixcon16 - 192.168.0.50 - When I get home tonight I will change the laptop to 192.168.0.100 and see if that works.

Link to comment
Share on other sites

  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...