Dmitriy Posted October 22, 2016 Share Posted October 22, 2016 Hello. Running CTB16 and 2 servodogs in dmx mode. Using LOR usb dongle. All addresses set property and dmx working. Issue 1 When in SE DITOR and saving sequence losing connection to controllers. Red lights start blinking. I have to uplug and plug cat5 cable from 1st controller to restore connection 4.5 times. Question. In network utility do I have to list COM3 in LOR tab ? In DMX tab my controller listed. And DMX listener running. Issue 2 Servodog changing Id number by itself Im changing manual again and agin. I even did firmware update. Link to comment Share on other sites More sharing options...
Recommended Posts