Dave76 Posted September 26, 2016 Share Posted September 26, 2016 Hope someone can help me. I picked up a laptop and attempted to move everything to the new laptop. All the LOR software installed without issue. However, when I start my visualization, and then play my sequence, the lights in the virtualization no longer blink. I have tried everything, verifying paths, LOR unit and channel counts are all the same between each. Anyone experience this and have any tips on how to overcome without having to rebuild my virtualization? Many Thanks. Dave Link to comment Share on other sites More sharing options...
B.Y.R.G. Posted September 26, 2016 Share Posted September 26, 2016 Make sure under the Play option in sequence editor that control lights and control visualizer are checked. Link to comment Share on other sites More sharing options...
ebrown1972 Posted September 26, 2016 Share Posted September 26, 2016 37 minutes ago, Dave76 said: Hope someone can help me. I picked up a laptop and attempted to move everything to the new laptop. All the LOR software installed without issue. However, when I start my visualization, and then play my sequence, the lights in the virtualization no longer blink. I have tried everything, verifying paths, LOR unit and channel counts are all the same between each. Anyone experience this and have any tips on how to overcome without having to rebuild my virtualization? Many Thanks. Dave It's always a good idea to make sure the comm listener is running also Link to comment Share on other sites More sharing options...
Dave76 Posted September 26, 2016 Author Share Posted September 26, 2016 14 minutes ago, B.Y.R.G. said: Make sure under the Play option in sequence editor that control lights and control visualizer are checked. BYRG thank you! The control visualizer was not checked. Cheers to you. Link to comment Share on other sites More sharing options...
Recommended Posts