Wychristmaslights Posted May 17, 2015 Share Posted May 17, 2015 Ok I have a CTB16 controller that's a couple years old. I haven't had any problems before with it and it worked fine last season. Got all the controllers out to test them this year and I can get power to the controller but can get any lights to come on and any channels to be recognized by the computer. Getting frustrated any ideas? Link to comment Share on other sites More sharing options...
1983ss454 Posted May 17, 2015 Share Posted May 17, 2015 Try a different cat5 cable Link to comment Share on other sites More sharing options...
George Simmons Posted May 17, 2015 Share Posted May 17, 2015 (edited) If the power light on the board is flashing it's not in communication with your PC. If it's on solid then you have an addressing problem somewhere. If there's no light at all, you have a power/fuse problem. Also, make sure you have only one program running at a time - either SE or HU - but not both at once. Edited May 17, 2015 by George Simmons Link to comment Share on other sites More sharing options...
Cheski Posted May 18, 2015 Share Posted May 18, 2015 What's the status of the Pixcon 16? Link to comment Share on other sites More sharing options...
jstorms Posted May 18, 2015 Share Posted May 18, 2015 Make sure the LOR control panel is running, then open up the HW Utility and do auto-configure on the comm port and see if that works. Link to comment Share on other sites More sharing options...
thomas666 Posted May 25, 2015 Share Posted May 25, 2015 Make sure that the color controls the panel operation, and then open the port, communication device, and auto configuration if the actual work is. Link to comment Share on other sites More sharing options...
Recommended Posts