Jump to content
Light-O-Rama Forums

Mike Kady

Recommended Posts

Hey, folks: a newbie here, and I'd appreciate any help. I'm working with LOR 3.11.2 that I just downloaded a couple of days ago. When I change the Play Range (say to "Selection"), I notice the audio played back through the speakers is no longer sync'd to the Visualizer. Everything on the monitor is displayed correctly on the Sequence Editor, including the waveform, but what I'm hearing is about two seconds off from what I'm seeing in the Visualizer. Am I missing a setting somewhere to keep the music through the speakers sync'd with the program? This makes is very hard to edit anything. The only way to make sure my changes are sync'd is to play the entire sequence from the beginning. Not very convenient if the changes are two to three minutes into the program.

Link to comment
Share on other sites

In almost every case this is a matter of the media file you are using not being a Constant Bit Rate MP3 file (or WAV file.)

See this PDF from LOR. It will show you how to use Audacity to make a Constant Bit Rate MP3 out of the file.

For a much more technical explanation of what's going on, see this post.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...